Connecting The Fm And Am Antennas; Connecting The Power Cable; Turning This Unit On And Off - Yamaha RX-V665 Owner's Manual

Connections

Connecting the FM and AM antennas

An indoor FM antenna and an AM loop antenna are
supplied with this unit. Connect these antennas properly to
the respective jacks.
Indoor FM antenna
Outdoor AM antenna
Connect a 5 to 10 m (16 to
33 ft) vinyl-covered wire,
and extend it outdoors
(use the AM loop antenna
together with this
antenna).
DOCK
PHONO
COMPONENT
VIDEO
P
R
GND
P
B
VIDEO
Y
Ground (GND terminal)
The GND terminal is not for earth grounding.
To reduce noises, connect a ground bar or a
vinyl-covered wire with a copper plate at its tip,
and place it in the moist ground.
y
• The supplied antennas are normally sensitive enough to obtain good
reception.
• Position the AM loop antenna away from this unit.
• If you cannot get good reception, we recommend that you use an outdoor
antenna. For more details, consult the nearest authorized Yamaha dealer
or service center.
• Always use the AM loop antenna even when the outdoor antenna is
connected.
Assembling the AM loop antenna
Connecting the AM loop antenna
The wires of the AM loop antenna have no polarity. You
can connect either wire to the AM terminal and the other
to the GND terminal.
Press and hold
18
En
AM loop
antenna
(BD/DVD)
HDMI OUT HDMI 1 HDMI 2 HDMI 3
ANTENNA
COMPONENT
VIDEO
REMOTE
UNBAL.
P
R IN
OUT
FM GND AM
P
B
VIDEO
12V
Y
0.1A MAX.
MONITOR OUT TRIGGER OUT
Insert Release

Connecting the power cable

VOLTAGE SELECTOR (Asia and General
models only)
Caution
The VOLTAGE SELECTOR on the rear panel of this
unit must be set for your local voltage BEFORE
plugging the power cable into the AC wall outlet.
Improper setting of the VOLTAGE SELECTOR may
cause damage to this unit and create a potential fire
hazard.
H
Select the switch position according to your local voltage
using a straight slot screwdriver.
VOLTAGE
FRO
SELECTOR
CENTER
230-
240V
[General model]
Voltages are AC 110/120/220/230-240 V, 50/60 Hz.
[Asia model]
Voltages are AC 220/230-240 V, 50/60 Hz.
Connecting the AC power cable
After all connections are complete, plug the AC power
cable of this unit into an AC wall outlet.

Turning this unit on and off

1
Press AMAIN ZONE ON/OFF (or
gPOWER) to turn on this unit.
2
Press AMAIN ZONE ON/OFF (or
gPOWER) again to turn off this unit
(standby mode).
y
• The unit needs a few seconds until ready to play back.
• You can also turn on this unit by pressing JSCENE (or lSCENE).
• This unit consumes a small amount of electricity even in the standby
mode. We recommend disconnecting the power cable from the AC wall
outlet.
Caution
Do not unplug this unit while it is turned on. Doing so
may damage this unit or cause the settings of this unit
to be saved incorrectly.
Voltage indication