Yamaha RX RX-Z7 Owner's Manual page 97

Manual parametric equalizer configuration of
each speaker
Use this feature to adjust the tonal quality of each speaker.
You can copy the results of the automatic setup for the
base of the manual configuration by using "PEQ Data
Copy". Set "PEQ Select" to "Manual" in advance.
1
Press 9 k / n / l / h to select "Test Tone" or
the speaker you want to adjust.
Choice
Front L Front left speaker
Front R Front right speaker
Center Center speaker
Surround L Surround left speaker
Surround R Surround right speaker
Surround Back L Surround back left speaker
Surround Back R Surround back right speaker
Front Presence L Front presence left speaker
Front Presence R Front presence right speaker
Subwoofer Subwoofer
Test Tone
Use this feature to select whether to turn on or off the
test tone output while you are adjusting the tonal
quality of each speaker.
Choice
On Outputs the test tone.
Off
Does not output the test tone.
2
Press 9 h to access the settings window.
PEQ Data Copy
PEQ Select
Front L
Front R
Center
3
Press 9 k / n / l / h to select "PARAM" and
then press 9 ENTER repeatedly to select a
parameter from "Band" (band), "Freq."
(frequency) or "Q" (Q factor).
y
You can adjust "Gain" (gain) with any parameter.
Adjusted speaker
Functions
PARAM RESET
EDIT EXIT
Band / Gain
Graphical user interface (GUI) menu
4
Press 9 n to select "EDIT" and press
9 ENTER to access the edit window.
For more information on the parametric equalizer and
each parameter, see page 153.
PEQ Data Copy
PEQ Select
Front L
Front R
Center
The parameter selected in "PARAM" is highlighted.
• Press 9 l / h to adjust the parameter.
• Press 9 k / n to adjust the "Gain".
• Press 9 ENTER to exit the edit window.
y
• When you select "Band" in step 3, you can use this menu
as a graphic equalizer.
• "Band #5", "Band #6", and "Band #7" can adjust the
frequencies of above 500 Hz.
• When you select "Subwoofer" in step 1 and "Band" in step 3,
you can adjust "Band #1", "Band #2", "Band #3" and "Band
#4" only. In this case, "Band #1", "Band #2", "Band #3" and
"Band #4" adjust the frequencies of below 200 Hz.
5
Repeat steps 3 and 4 until you are satisfied
with the results.
y
If you want to reset all "Parametric EQ" parameter settings
for the selected speaker, select "RESET" and press
9ENTER.
Select "EXIT" and press 9 ENTER to exit
6
from the settings window.
■ Tone Control (Tone control)
Use this feature to adjust the balance of bass and treble
output to your speakers or headphones.
Note
Tone Control is not effective when:
– the PURE DIRECT mode (page 54) is selected.
– MULTI CH is selected as the input source.
Control (Control mode)
Choice
Speaker Adjust the bass/treble balance of your speakers.
Headphone Adjust the bass/treble balance of your
headphones.
y
"Speaker" and "Headphone" adjustments are stored
independently. The adjustments for "Speaker" affects the front
left/right speaker, center speaker and subwoofer channels.
Band #1
Gain 0.0dB
Freq 62.5Hz
Q 1.000
Exit:ENTER
Functions
97
En