Programming Codes From Other Remote Controls - Yamaha RX RX-Z7 Owner's Manual

Remote control features
Programming codes from other
remote controls
You can program remote control codes from other remote
controls. Use the learning feature if you want to program
functions not included in the basic operations covered by
the remote control codes, or an appropriate remote control
code is not available. You can program the function of
other remote control to the buttons in the highlighted areas
in the following illustration. The buttons can be
programmed independently for each control area.
POWER POWER STANDBY POWER
TV AV
MULTI V-AUX PHONO DOCK
BD MD
DVD CD
HD DVD CD-R
CBL
TV DVR VCR
SAT
USB
TUNER XM SIRIUS
NET
Set to
AMP
TV
SOURCE
SOURCE
SELECT SETUP ID MACRO
MODE ZONE
SYSTEM MEMORY
1 2 3 4
STATUS
VOLUME
PRESET/CH
TITLE MENU
BAND SRCH MODE
CAT.
ENTER
A-E
SUBMENU PLAY INFO
RETURN DISPLAY
MEMORY
MUTE
REC
Notes
• The remote control transmits infrared rays. If the other remote
control also uses infrared rays, this remote control can learn
most of its functions. However, you may not be able to program
some special signals or extremely long transmissions.
• You cannot program the desired remote control code even if you
select the buttons in the highlighted area in the above
illustration depending on the selected control area and the
assigned library.
1
Set the operation mode selector to
FSOURCE and then press an input selector
button (3) to select the desired control area.
If you want to program the remote control code for
"TV", set the operation mode selector to FTV.
Note
Make sure that the operation mode selector is set to
F SOURCE or FTV. When you set the operation mode
selector to FAMP and program a remote control codes
from other remote controls, the programmed key cannot
operate the amplifier function of this unit.
2
Press GSETUP using a ballpoint pen or
similar object.
"SETUP" appears in the display window (4).
3
Press 9k / n repeatedly to select "LEARN"
and then press 9ENTER.
118
En
4
STATUS VOLUME
PRESET/CH
TITLE MENU
BAND SRCH MODE
CAT.
ENTER
A-E
SUBMENU PLAY INFO
RETURN DISPLAY
MEMORY
MUTE
REC
TAG PRG SELECT
CLASSICAL LIVE/CLUB ENTERTAIN MOVIE
5
1 2 3 4
STEREO ENHANCER SUR.DECODE STRAIGHT
5 6 7 8
HDMI OUT EXTD SUR. PURE DIRECT
9 0 10 ENT
INFO LEVEL SLEEP AUDIO SEL
MUTE AUDIO
TV VOL TV CH TV
INPUT
PARTY 3D DSP
6
Place this remote control about 5 to 10 cm (2
to 4 in) apart from the other remote control
on a flat surface so that their infrared
transmitters are aimed at each other and
then press 9ENTER.
"L–KEY" appears in the display window (4).
5 to 10 cm (2 to 4 in)
Press the button for which you want to
program the new function.
"START" appears in the display window (4).
Press and hold the button you want to
program on the other remote control until
"OK" appears in the display window (4).
"NG" appears in the display window (4) if learning
was unsuccessful. In this case, start over from step 4.
y
When you want to program another function, repeat steps
4 through 6.
Other remote control
Other remote control
OK