Troubleshooting - Yamaha RX RX-Z7 Owner's Manual

Yamaha av receiver owner's manual
Hide thumbs Also See for RX RX-Z7:
Table of Contents

Advertisement

Refer to the table below when this unit does not function properly. If the problem you are experiencing is not listed below
or if the instruction below does not help, turn off this unit, disconnect the power cable, and contact the nearest authorized
Yamaha dealer or service center.
■ General
Problem
This unit fails to turn
The power cable is not connected or the
on or enters the
plug is not completely inserted.
standby mode soon
The speaker impedance setting is
after the power is
incorrect.
turned on.
The protection circuitry has been
activated.
This unit has been exposed to a strong
external electric shock (such as lightning
or strong static electricity).
No sound.
Incorrect input or output cable
connections.
Audio input jack select is set to "HDMI",
"COAX/OPT" or "ANALOG".
Audio input jack select is set to
"ANALOG" while the input source
component outputs digital audio signals.
No appropriate input source has been
selected.
Speaker connections are not secure.
The volume is turned down or muted.
Signals this unit cannot reproduce are
being input from a source component,
such as a CD-ROM.
The HDMI components connected to this
unit do not support the HDCP copy
protection standards.

Troubleshooting

Cause
Connect the power cable firmly.
Set the speaker impedance to match your speakers.
Make sure that all speaker wire connections on this
unit and on all speakers are secure and that the wire
for each connection does not touch anything other
than its respective connection.
Turn off this unit, disconnect the power cable, plug it
back in after 30 seconds and then use it normally.
Connect the cables properly. If the problem persists,
the cables may be defective.
Set the audio input jack select to "AUTO".
Set the audio input jack select to "AUTO" or
"COAX/OPT".
Select an appropriate input source with the L INPUT
selector (or the input selector buttons (3)).
Secure the connections.
Turn up the volume.
Play a source whose signals can be reproduced by this
unit.
Connect HDMI components that support the HDCP
copy protection standards.
TROUBLESHOOTING
Remedy
See
page
31
17
23-29
43
43
42, 43
17
21
133
En

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rx-z7bl

Table of Contents