Fm/Am Tuning; Overview; Fm/Am Tuning Operations - Yamaha RX RX-Z7 Owner's Manual

Overview

You can use two tuning modes to tune into the desired
FM/AM station:
Frequency tuning mode
You can search or specify the frequency of the desired
FM/AM station automatically or manually (see "FM/AM
tuning operations" on this page).
Preset tuning mode
You can preset the desired FM/AM station in advance, and
then recall the station by specifying the preset group and
number (see "Recalling a preset station" on page 58).
Note
Orient the connected FM and AM antennas for the best
reception.
Before performing the following operations, set the operation
mode selector on the remote control to FSOURCE and then
press 3TUNER.

FM/AM tuning operations

1
Press IBAND (or 8BAND) to select the
desired reception band.
2
If the PRESET indicator in the front panel
lights up, press GSEARCH MODE (or
ISRCH MODE) to turn it off.
F M 8 8 . 9 M H z
PRESET turns off
3
To search the station automatically, press
and hold EPRESET/TUNING/CH l / h (or
press 9PRESET/CH k / n) for about 2
seconds. To search the station manually,
press EPRESET/TUNING/CH l / h
repeatedly.
• To tune into a higher frequency,
press Eh (or 9k).
• To tune into a lower frequency,
press El (or 9n).
56
En

FM/AM tuning

Note
If the signal from the station you want to select is weak,
search the station manually or enter the frequency directly
(page 56).
y
• When this unit is tuned into a station, the TUNED
indicator lights up.
• To switch the information (current input source, current
sound field program, etc) displayed in the front panel
display, press JINFO (or set the operation mode to
FAMP and then press CINFO) repeatedly.
• To switch between stereo or monaural FM reception, press
HSTEREO/MONO (or OAUDIO).
• (U.S.A. model only)
If this unit is tuned into an HD Radio station (page 59), the
HD indicator lights up in the front panel display.
■ Direct frequency tuning
Use this feature tune into the desired station directly by
entering the frequency.
1
Follow steps 1 and 2 in "FM/AM tuning
operations" (page 56) to select the desired
reception band.
2
Enter the frequency of the desired station by
pressing the numeric buttons (B).
Example: To tune into 103.7 MHz
1
y
If the entered frequency is out of the range of the FM/AM
tuning, "WRONG STATION!" appears in the front panel
display.
0 3 7