Yamaha RX RX-Z7 Owner's Manual page 39

6
Press 9k / n repeatedly to set the number of
listening positions and press 9l.
Choices: 1 (default), 2, 3, 4, 5, 6, 7, 8
Information
Setup Menu
Start
7
To select the parameters to be optimized,
press 9k / n to select the parameter and
then press 9ENTER to check or uncheck
the box.
When you do not need to select the parameters to be
optimized, skip to step 8.
y
If you do not select the parameters to be optimized, this
unit will optimize the parameters you selected last time.
All the parameters except "Angle" are selected by the
initial factory settings.
8
Press 9l to return to the previous menu
level and then press 9n to select "Start".
Before proceeding next operation
Once you perform the next operation, this unit starts the
automatic setup procedure in 10 seconds. During the
automatic setup procedure, do not perform any operation on
this unit. For more accurate measurements, we recommended
that you get out of the room or move to the wall where
speakers are not around during the measurement.
9
Press 9ENTER to start the measurement.
This unit starts to count down from 10 seconds.
y
• To start the measurement immediately, press 9ENTER
again.
• To cancel the automatic setup and return to the previous
screen, press ?RETURN and then 9ENTER.
Loud test tones are output from each speaker during
the measurement. Once all items for the first listening
position are measured, the following message
appears.
Pre Check
Main Check
Wiring
Distance
Multi Measure 7
Wiring
Distance
Put the microphone at
2nd listening position
Next:ENTER
Skip: [ ]
Optimizing the speaker setting for your listening room
Note
If an error or warning message appears, see "Error and
warning messages" (page 38).
10
Move the optimizer microphone to the
second listening position and then press
9ENTER to start the measurement.
y
To skip the measurements at the remaining listening
positions, press 9n.
11
Repeat step 10 until the measurement at all
listening positions are made.
If you have selected "Angle" in step 7, follow steps 7
to 13 in "Basic automatic setup" (page 36).
If you have not selected "Angle" in step 7,
"Measurement Completed Successful" appears once
all items are measured. Follow steps 11 to 13 in
"Basic automatic setup" (page 36).
39
En