Yamaha RX RX-Z7 Owner's Manual page 141

■ Remote control
Problem
The remote control Wrong distance or angle.
does not work or
function properly.
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit.
The batteries are weak.
The batteries do not last long and get
quickly exhausted.
The operation mode selector is set
incorrectly.
The control zone setting is incorrect.
The remote control code is not correctly
set.
The remote control ID of the remote
control and this unit do not match.
Even if the remote control code is
correctly set, there are some models that
do not respond to the remote control.
The remote control The batteries of this remote control and/or
does not learn new the other remote control are too weak.
functions.
The distance between the two remote
controls is too much or too little.
The signal coding or modulation of the
other remote control is not compatible
with this remote control.
Memory capacity is full.
Cause
The remote control will function within a maximum
range of 6 m (20 ft) and no more than 30 degrees off-
axis from the front panel.
Reposition this unit.
Replace all batteries.
Using alkaline batteries is strongly recommended.
Set the backlight mode to "OFF".
Set the operation mode selector correctly. When
operating this unit, set it to the F AMP position.
When operating the component selected by the input
selector button, set it to the F SOURCE position.
When operating the TV set in the 3 TV area, set it to
the F TV position.
Select the zone you want to control.
Set the remote control code correctly using
"List of remote control codes" in "Appendix"
(separate booklet).
Try setting another code of the same manufacturer
using "List of remote control codes" in "Appendix"
(separate booklet).
Match the remote control ID of this unit and the
remote control.
Program the necessary functions independently into
the programmable buttons using the Learn feature.
Replace the batteries.
Place the remote controls at the proper distance.
Learning is not possible.
Delete other unnecessary functions to make room for
the new functions.
Troubleshooting
Remedy
See
page
33
—
9
—
116
—
127
116
116
123, 130
118
9
118
—
122
141
En