Yamaha RX RX-Z7 Owner's Manual page 41

y
The results of the measurement that are the causes of the
warning message(s) appear in yellow or pink.
Notes
• "–––" appears when no speaker is connected to the
corresponding speaker channel or this unit does not measure the
corresponding speaker channel yet.
• If you change speakers, speaker positions, or the layout of your
listening environment, run the automatic setup again to
recalibrate your system.
• The distances displayed in the "Distance" results may be longer
than the actual distance depending on the characteristics of your
subwoofer or external amplifiers if you connect them.
• In the "Equalizing" results, different values may be set for the
same band to provide finer adjustments.
6
To reload the displayed parameter, press
9ENTER.
7
Press IMENU to turn off the GUI menu.
y
• You can also set the parametric equalizer type with "PEQ
Select" (page 96).
• You can set the phase of the connected subwoofer with "Phase"
(page 93).
Optimizing the speaker setting for your listening room
41
En