Connecting The Speaker Cable - Yamaha RX RX-Z7 Owner's Manual

■ Connecting the speaker cable

1
Remove approximately 10 mm (0.4 in) of
insulation from the end of each speaker
cable and then twist the exposed wires of the
cable together to prevent short circuits.
10 mm (0.4 in)
2
Loosen the knob, insert one bare wire into
the hole and then tighten the knob.
Loosen Insert
■ Connecting the banana plug
Tighten the knob and then insert the banana plug
into the end of the terminal.
Tighten
Banana plug
■ Using bi-amplification connections
Caution
Remove the shorting bars or bridges of your speakers to
separate the LPF (low pass filter) and HPF (high pass filter)
crossovers.
You can make bi-amplification connections to one speaker
system which supports bi-amplification connection as
shown below. To activate the connections, configure the
"BI-AMP" setting (page 131).
This unit
SURROUND BACK/BI-AMP
R
R
Right
Front speakers
Note
When you make the conventional connection with the speakers,
make sure that the shorting bars are put into the terminals of the
speakers appropriately. Refer to the instruction manuals of the
speakers for details.
Connections
L
+
SINGLE
FRONT
L
+
Left
19
En