Using The Sleep Timer - Yamaha RX RX-Z7 Owner's Manual

■ Video information
HDMI signal Type of the source video signals and
the video signals output at the HDMI
OUT jacks of this unit.
HDMI Resolution Resolution of the input signal (analog
or HDMI) and the output signal
(HDMI).
Analog Resolution
Resolution of the source video signals
and the analog video signals output at
the COMPONENT MONITOR OUT
jacks of this unit.
HDMI Error Error message for HDMI sources or
connected HDMI devices.
HDMI error message
Device Over
The number of the connected HDMI
components is over the limit.
HDCP Error
HDCP authentication failed.
(HDMI Message)
Out Of Resolution Out of resolution. The connected
monitor is not compatible with the
resolution of the input video signal.

Using the sleep timer

Use this feature to automatically set the main zone to the
standby mode after a certain amount of time. The sleep
timer is useful when you are going to sleep while this unit
is playing or recording a source. The sleep timer also
automatically turns off any external components
connected to the AC OUTLET(S) (page 30).
Set the operation mode selector to FAMP and
then press CSLEEP on the remote control
repeatedly to set the amount of time.
The sleep timer setting changes as shown below.
120min.
OFF 30min.
Once the sleep timer is set, the SLEEP indicator lights up
in the front panel display, and the display returns to the
selected sound field program.
To cancel the sleep timer
Set the operation mode selector to FAMP and then press
CSLEEP on the remote control repeatedly to select
"SLEEP OFF".
y
If you set the main zone to the standby mode, the sleep timer is
automatically canceled.
Playback
90min.
60min.
45
En