Using The Zone Osd - Yamaha RX-V3900 Owner's Manual

Using multi-zone configuration
■ Selecting the input source of Zone 2 or
Zone 3
Rotate the CINPUT selector (or set the
operation mode selector to FAMP and then
press one of the input selector buttons (3)).
• Select "TUNER" as the input source to use the FM/AM
tuning features (page 48) in the selected zone.
• Select "XM" as the input source to use the XM
Satellite Radio features (page 53) in the selected zone.
• Select "SIRIUS" as the input source to use the SIRIUS
Satellite Radio features (page 58) in the selected zone.
• Select "DOCK" as the input source to use the iPod
features (page 66) or Bluetooth features (page 64) in
the selected zone.
• Select "USB/NET" as the input source to use the USB
features (page 69) or network features (page 69) in the
selected zone.
Note
The input sources are shared across all zones.
■ Adjusting the volume level of Zone 2 or
Zone 3
Rotate P VOLUME (or press J VOLUME +/–) .
y
Press L MUTE on the remote control to mute the sound output
to the selected zone.
Note
When you use the external amplifiers in Zone 2 or Zone 3,
J VOLUME +/– can be used only when "Zone2 Volume" or
"Zone3 Volume" is set to "Variable" (page 96).
■ Adjusting the front speaker balance of
Zone 2 or Zone 3
Press DTONE CONTROL repeatedly to select
"BALANCE" and then rotate the MPROGRAM
selector for adjustment.
■ Adjusting the tonal quality of Zone 2 or
Zone 3
Press DTONE CONTROL repeatedly to select
the high-frequency response (TREBLE) or the
low-frequency response (BASS) and then rotate
the MPROGRAM selector for adjustment.
Control range: -10.0 dB to +10.0 dB
120
En
■ Setting the sleep timer for Zone 2 or
Zone 3
Use this feature to turn of the desired zone after a certain
amount of time.
Set the operation mode to FAMP and then press
CSLEEP repeatedly to set the amount of time.
The sleep timer setting changes as shown below.
120min.
OFF

■ Using the zone OSD

You can display the FM/AM radio, XM Satellite Radio
(U.S.A. and Canada models only), or HD Radio
information (U.S.A. model only) in the video monitor
connected to the ZONE VIDEO jacks. You can also
browse music contents (such as iPod contents) by using
the zone OSD.
1
Set the operation mode selector to
FSOURCE and then press the desired input
selector button (3).
2
Press KDISPLAY to display the menu
screen on the zone OSD.
3
Use 9k / n / l / h and 9ENTER to
navigate the menu on the zone OSD.
Notes
• The menu displayed in the zone OSD appears in English
even if Japanese or Russian is selected.
• There are some characters that cannot be displayed in the
front panel display or in the OSD of this unit. Those
characters are replaced with underscores "_".
y
• You can select the zone(s) of which the operational status
is displayed (page 97).
• You can operate the zone OSD in the same way as GUI
operations.
90min.
30min. 60min.