Peri MULTIPROP Instructions For Assembly And Use page 8

Introduction
Care and maintenance instructions
Clean the panels after every use to
maintain the value and usability of the
PERI products over the long term.
Some repair work may also be inevitable
due to the tough working conditions.
The following points should help to keep
care and maintenance costs as low as
possible.
Never use steel brushes or hard metal
scrapers to clean powder-coated or
galvanised components.
Mechanical components, e.g. spindles,
must be cleaned of dirt or concrete
residue before and after use and then
greased with a suitable lubricant.
Provide suitable support for the
components during cleaning so that no
unintentional change in their position is
possible.
Do not clean components when
suspended on a crane.
Repairs must be carried out by
PERI-trained personnel only.
MULTIPROP System
6 Instructions for Assembly and Use – Standard Configuration