Mounting The Standard Gps Antenna Bracket - Raven SBGuidance Auto Installation Manual

6.1 Mounting the standard GPS antenna
bracket
Figure 41 shows an example of the structure of
standard GPS antenna equipment, which consists of a
standard GPS antenna bracket, a GPS dummy and an
UNC bolt + nut. The standard GPS antenna bracket can
be taped to the cab roof using double-sided adhesive
tape.
The following guidelines must be observed when
installing the GPS antenna:
The GPS antenna must be mounted at least 60

cm in front of the rear axle.
Mount the GPS antenna in the centre of the

tractor.
Mount the GPS antenna using the UNC bolt

included.
Fasten the TNC-dummy to the GPS antenna

bracket.
Wire the antenna cable connector with the

largest connector through to the inside of the
cabin.
Fasten the antenna cable so that it cannot

become pinched anywhere and conceal inside
the cabin upholstery, together with the GPS
patch antenna cable, radio antenna cable or
UMTS antenna cable.
Mount the antenna cable in such a way that no

water is allowed to flow along the cable into
the cabin.
Label the antenna cable inside the cabin with

label 'GPS1'.
Page38/52 I SBG-Auto CAN-EN-Rev. A
SBGuidance Auto I Rev. A I CAN
Figure 41 Standard GPS-antenna bracket with UNC
nut and bolt and TNC-dummy.