Mounting Dynamiq Iso - Raven SBGuidance Auto Installation Manual

SBGuidance Auto I Rev. A I CAN

7. Mounting DynamIQ ISO

The following guidelines have been established for
mounting the DynamIQ ISO:
Preferably, place the DynamIQ ISO next to and

to the right of the seat. Use the standard
DynamIQ ISO mounting bracket.
If it is not possible to attach the DynamIQ ISO

to the seat bolts, the DynamIQ ISO should be
attached in an appropriate place in the cabin
that is free from vibrations.
A DynamIQ ISO may only be mounted in a

horizontal position (with the sticker side up).
The connectors may be orientated in four
directions (0, 90, 180, 270 degrees).
By default, the orientation of the DynamIQ ISO

is set to: horizontal position with connectors
pointing towards the rear (as shown in Figure
50). Any other orientation should be set in the
software!
Figure 50 DynamIQ ISO mounted next to the seat.
SBG-Auto CAN-EN-Rev. A I Page 45/52