Mounting And Connecting The Steering Controller - Raven SBGuidance Auto Installation Manual

SBGuidance Auto I Rev. A I CAN
3.6 Mounting and connecting the steering
controller
The steering controller bracket can be mounted to the
manifold. The steering controller can then be fitted to
the manifold bracket (Figure 11).
Important notes when mounting the controller:
Mount the steering controller with connectors

directed downwards to prevent the ingress of
water.
Do not mount the steering controller too close

to parts which have a high temperature (for
example, the exhaust system of the tractor).
Connect the DIN connectors marked "Left" and "Right"
to the proportional valve. Connect the DIN connector
marked "Lock" to the shut-off valve. Connect the 4-pin
Phoenix M12 connector to the pressure sensor of the
manifold.
Pay attention!:
The torque of the pressure sensor in the
manifold V3 is 50 Nm. It is not necessary to
check this at delivery of a completely
assembled manifold. However, make sure,
when replacing the pressure sensor, that it is
tightened with the correct torque.
Figure 11 Side view of the steering controller fitted
to the manifold.
SBG-Auto CAN-EN-Rev. A I Page 21/52