Mounting The Wheel Angle Sensor; Mounting Of Wheel Angle Sensor Housing To Standard Front Axle - Raven SBGuidance Auto Installation Manual

5.2 Mounting the wheel angle sensor

Figure 22 and Figure 23 show a detailed view of the
structure of a wheel angle sensor assembly. Table 1
also lists the components shown in Figure 22.
Table 1 Wheel angle sensor components.
Symbol Description
1 Sensor housing
2 Sensor disc
3 Mounting bracket 3mm
4 Mounting strip 20x 3mm
5 2 x M5 x 16mm (countersunk
head)
6 2 x M5 x 30mm
5.2.1 Mounting of wheel angle sensor housing
to standard front axle
1. If the front wheels are straight, the screws of
the sensor housing and sensor disc should be
aligned with the front axle. In case of a 12V
wheel angle sensor, it is also important that the
sensor disc is rotated in such a way that the
triangles in the disc and the sensor housing
(Figure 24) are properly aligned. Only then will
the wheel angle sensor produce a voltage
reading.
2. The sensor housing and sensor disc must be
aligned EXACTLY on the pivot point of the stub
axle. The centre-to-centre distance of the
mounting holes is 28 mm.
Please note!:
With a 12V wheel angle sensor, the triangles on
the sensor housing and sensor disc must be
pointing in the same direction!
Page30/52 I SBG-Auto CAN-EN-Rev. A
SBGuidance Auto I Rev. A I CAN
Figure 22 Schematic overview of wheel angle
sensor with mounting bracket and strip.
Figure 23 Schematic drawing of wheel angle sensor
when mounted.