Raven SBGuidance Auto Installation Manual page 35

SBGuidance Auto I Rev. A I CAN
Tip!:
It is often useful to drill bigger holes (slots) in
the wheel angle sensor strip for the sensor disc.
Allow the nuts to be loose-fit when mounting
the strip. The disc then centers itself
automatically. Do not forget to tighten the nuts
again.
Caution!:
Make sure the magnet of the wheel angle sensor
is completely clean (no iron fillings) before
mounting it. Cleaning the wheel angle sensor
magnet with compressed air can prevent
problems.
Figure 35 Centre and friction check of wheel angle
sensor.
Figure 36 Correct mounted wheel angle sensor.
SBG-Auto CAN-EN-Rev. A I Page 35/52