Mounting The Wiring Harness; Can Basic Power Harness; Can Implement Ready (Ir) Power Harness - Raven SBGuidance Auto Installation Manual

SBGuidance Auto I Rev. A I CAN

4. Mounting the wiring harness

The total SBG cable harness exist of several cables,
from the battery to the terminal (see Figure 53 and
Figure 54). SBG offers two power harness options; the
CAN Basic harness or the Implement Ready (IR)
harness. As an in-cab terminal harness SBG offers a
harness to connect the Viper 4(+) or the older GeoStar
terminal. With an adapter harness it is also possible to
connect a Viper 4(+) to the GeoStar terminal harness.

4.1 CAN Basic Power harness

The basic harness can only be used for tractor steering.
If the tractor is fitted with this harness, it is not
possible to use the tractor for implement steering
(TWIN, plough).

4.2 CAN Implement Ready (IR) Power harness

With an Implement Ready harness the tractor can be
used both for tractor and implement steering. The
IBBC connector can be used to connect an implement
(Figure 12). The Implement Ready power harness runs
from the battery to the IBBC connector at the rear of
the tractor. It branches off to connect the STU chassis
harness and contains fuses near the split.
Figure 12 IBBC bracket with connector.
SBG-Auto CAN-EN-Rev. A I Page 23/52