The Debug-Interface; Overview Of The Debug-Interface; Starting In The Debug-Mode; Communication Parameter For The Debug-Interface - DEUTSCHMANN AUTOMATION UNIGATE IC2 - Fast Ethernet Instruction Manual

Deutschmann Automation GmbH & Co. KG
6

The Debug-interface

6.1

Overview of the Debug-interface

®
The UNIGATE IC2 features a Debug-interface, that allows a step-by-step processing of a
Script. Normally this interface is only required for the development of a Script.
6.2

Starting in the Debug-mode

When applying power to the UNIGATE
character 0 (0x00) after a self-test was carried out on this interface. If the IC2 receives an
acknowledgement via this interface within 500 ms, it is in the Debug-mode. The
acknowledgement is the ASCII-character O (0x4F).
With the start in the Debug-mode the further execution of Script-commands will be put to a stop.
6.3

Communication parameter for the Debug-interface

The Debug-interface is always operating with 9600 baud, no parity, 8 data bit, 1 stop bit. It is not
possible to change this parameter in the Protocol Developer. Please consider the fact that these
settings have to be in accordance with those of the PC-COM-interface and that the flow control
(protocol) has to be set on „none" there.
6.4

Possibilities with the Debug-interface

Usually the Protocol Developer is connected to the Debug-interface. With it a step-by-step pro-
cessing of a Script, monitoring jumps and decisions and looking at memory areas is possible.
Moreover breakpoints can be set. It basically possesses all characteristics a software-develop-
ment tool is typically supposed to have. However, it is also possible to carry out a Scrip-update
via this interface.
6.5

Commands of the Debug-interface

The commands for the use of the Debug-interface are described in the instruction manual Proto-
col Developer.
3.4.20
®
IC2 (power up) the firmware will output the binary
Instruction manual UNIGATE
®
IC2 - Fast Ethernet V. 1.2
The Debug-interface
26