Table of Contents
Advertisement
System update
When updating the firmware of the fieldbus coupler, the saved module parameters
may be overwritten. Therefore, check your existing configuration after updating
the firmware.
Perform the system update here. The module settings you made normally remain
unchanged. Otherwise, a corresponding warning message appears. If you still
want to update the firmware, the 767 components are returned to their default
state.
1.
Click "System Update" in the left window.
2.
The fieldbus coupler with all connected I/O modules are listed in the right
window. All 767 components that can be updated are pre-selected. If the
pre-selection is incorrect or if specific 767 components should not be
updated, deselect them.
"Actual: Version":
"Target: Version": Version of the firmware that should be loaded into the
767 components. If multiple "Target" versions can be selected, select the
one relevant to you.
WAGO-SPEEDWAY 767
Fieldbus Coupler for CANopen
Note
Firmware currently present on the device
System Update
41
Advertisement
Table of Contents
