Table of Contents
Advertisement
Setting the serial interface parameters for the "WAGO Service Interface"
communication DTM.
1.
Select the interface to be used from the list and accept these settings.
If there are no entries in the list of available interfaces, check to ensure that
the fieldbus coupler is switched on and that it is connected to your PC by the
USB communication cable.
2.
To complete the network configuration you can now select individual
DTMs from the catalog, or conduct a network scan.
When adding elements manually please note that each FDT frame application
differentiates between online and offline modes. Each of these modes has a
separate scope of functions.
In the online mode, there is a direct link between the display and the connected
767 components.
The offline mode enables the parameterization of a device that is not yet present.
It will continue to be used to reduce data transfer between WAGOframe and the
device. If a device is in the online mode, its name is displayed in bold and cursive
font in the network window.
WAGO-SPEEDWAY 767
Fieldbus Coupler for CANopen
WAGOframe
33
Advertisement
Table of Contents
