Table 57: "Scaling" > "Channel 1 - WAGO 750-451 Manual

80 Commissioning
Table 57: "Scaling" > "Channel 1 ...8" Menu Item
Option
Line resistance
Offset line resistance
Scaling settings
Enable manufacturer
scaling
Enable user scaling
Offset
Gain multiplier
Gain divisor
Process value
The user has the option of scaling the measured values calculated by the I/O
module. A linear equation is applied to the sensor-specific measurement variable:
• y2 = ((y1 × Reg40) / Reg41) + Reg39
The variables are assigned as follows:
• y2= scaled process value
• y1= unscaled process value
• Reg40= gain multiplier
• Reg41= gain divisor = set to 256 by default
• Reg39= scaling offset
The gain multiplier and scaling offset values are required for user scaling. After
entering both factors, you receive a scaled process value as the result. The gain
divisor determines the resolution of the gain multiplier. The gain divisor is set to
256 by default.
Manual
Version 1.2.0
Description
Enter the line resistance to be observed when calculating the measured
values.
Manufacturer scaling is enabled. Manufacturer-side scaling is

applied. The gain multiplier, gain divisor and offset cannot be
entered individually.
Manufacturer scaling is disabled.

User scaling is enabled. By enabling user scaling, the gain

multiplier and offset can be specified individually.
User scaling is disabled.

The offset value moves the zero point of the unscaled process value
(offset on the y axis).
The gain multiplier changes the slope factor of the unscaled process
value.
The gain divisor determines the resolution of the gain multiplier. The gain
divisor is 256 by default.
The process value is the resistance or temperature value resulting from
the temperature or resistance measurement. The process value is given in
°C or Ohm depending on the sensor type set.
WAGO-I/O-SYSTEM 750
750-451 8 AI RTD