Table 3.2 Types Of Control Boards - Samsung OfficeServ 7400 Technical Manual

OfficeServ 7400
TECHNICAL MANUAL
3.2.2 Installing MP40 and LP40
Install the LP40 into Slot 0 of the main cabinet and each expansion cabinet (if the
expansion cabinet is an OS7200 cabinet, then install an LCP card into slot 0). Install the
MP40 in slot 3 of the MAIN cabinet.
Control Board
MP40
LP40
OS7200 LCP
The procedure for installing the MP40 board and the LP40 board to each slot is as
follows:
1) Check the exterior of the MP40 board and the LP40 board for any damage. If
damage is found, do not proceed with installation. Contact Samsung Technical
Support.
Power the system OFF when installing or removing boards.
POWER TO THE CABINET MUST BE TURNED OFF. Failure to do so will
damage the card, cabinet and/or corrupt the data moving along the data bus.
2) Align the MP40 board to the guardrails of the Main cabinet slot 3, and slide the MP40
board into the slot.

Table 3.2 Types of Control Boards

Slot 3 of the Main Cabinet
Slot 0 of each OS7400 cabinet (MAIN and OS7400 Expansion
cabinets)
Slot 0 of OS7200 expansion cabinets
Figure 3.5 Installing the Processor Board (1)
3.7
Home Page
PART 3 JUNE 2006
Applicable Slot
Table of Contents
INSTALLATION