OfficeServ 7400
TECHNICAL MANUAL
4) Match the cross bar bracket attached to the 7150 to the two holes in the bracket
inside the rack properly and then tighten with screws.
INSTALLATION ON THE FLOOR
Observe the following requirements to install OfficeServ 7150 on the floor.
•
Install the system at a place with good air ventilation and no humidity.
•
Do not block the front fan of the OfficeServ 7150.
•
Do not block the rear air ventilation of the OfficeServ 7150.
GROUND WIRE CONNECTION
This section describes how to connect external grounding wire to the OfficeServ 7150.
Follow the grounding conditions and guidelines in section 1.2 for grounding
the OfficeServ 7150.
As shown in the following illustration, connect the grounding wire to the grounding lug
at the rear of the OfficeServ 7150 cabinet.
Figure 5.9 Installation in a Rack (4)
5.11
Table of Contents
Home Page
INSTALLATION
PART 5 JUNE 2006