Samsung OfficeServ 7400 Technical Manual page 30

Table of Contents
Home Page
OfficeServ 7400 INSTALLATION
TECHNICAL MANUAL PART 3 JUNE 2006
Mount the MODEM as shown below:
MODEM
Figure 3.13 Installing Optional Modem daughter card on the MP40
3.3 INTERFACE BOARDS
This section describes how to set jumpers and switches of an interface board, how to
install optional daughter boards to an interface board, and how to install interface
boards into slots.
3.3.1 Installing Interface Boards
Interface boards can be installed in any universal slot according to the rules outlined in
table 3.1. Universal slots are slots 1, 2, and 4~11 in the MAIN cabinet and slots 1~11
in the OfficeServ 7400 expansion cabinets. For OS7200 expansion cabinets, universal
slots are slots 1~5.
The Procedure for installing the interface board to each slot is as follows:
1) Check the exterior of the interface board for any damage.
TURN OFF ALL POWER TO THE SYSTEM BEFORE INSTALLING A CARD.
Align each Interface board to the guardrails of the universal slot and slide the Interface
board into the slot.
3.15