Samsung OfficeServ 7400 Technical Manual page 60

OfficeServ 7400
TECHNICAL MANUAL
SVMi-20E FRONT PANEL
The Serial Interface: This can be used to connect a modem or PC to provide local or
remote PC based administration. The connector is called the SIO connector.
The LAN Interface: This is used for data transfer or database back up. The connector
is called the LAN connector. The main purpose for this connector is for system file
transfer (Back-up and Restore) as well as for use with E-Mail Gateway functionality. The
SVMi-20E is designed to back up and restore data to the customer provided LAN, or
directly to a PC or Laptop connected to this LAN connector. The E-Mail Gateway
functionality is used to send voice messages to E-Mail.
Reset Button: The sunken button marked RST is the reset button. Pressing this will
immediately restart the SVMi-20E system and will disconnect any calls in progress.
Since pressing the RESET button during operation will disconnect all callers and
immediately restart the SVMi-20E, it should only be used as directed. Pressing this
button when the system is performing Disk I/O could result in data loss or file
corruption. This button should not be pressed if the SVMi-20E is actively processing
calls.
LED INDICATIONS
There are Eight (8) LEDs on the SVMi-20E, the one marked HD will flash whenever the
hard disk drive is being accessed, others will give indications of various board
functionality.
• VM1 Status LED: This indicates that one or more of the embedded ports (port 1 thru
4) are off hook.
• VM2 Status LED: This indicates that one or more of the ports on the 1st installed
VPM are off hook.
• VM3 Status LED: This indicates that one or more of the ports on the 2nd VPM are
off hook.
• HDD Access LED: The HDD access LED will flash whenever the Hard Drive or CF
is being accessed.
• LAT Status LED: This indicates that the LAN port is active
Figure 3.42 SVMi-20E LED Indications
3.45
Table of Contents
Home Page
INSTALLATION
PART 3 JUNE 2006