Samsung OfficeServ 7400 Technical Manual page 64

OfficeServ 7400
TECHNICAL MANUAL
1. MMC 601: All SVMi-20E ports installed must be assigned to the last station group
(by default the last group number is 5049). This should be identified as Bi-VMS
group type by WebMMC.
2. MMC 601: Select either SEQUENTIAL or DISTRIBUTED ring mode (Sequential is
recommended).
3. MMC 207: Confirm that all SVMi-20E ports are set for VMAA use. This will be done
automatically. You are just confirming at this point.
4. MMC 406: If you are using the SVMi-20E for Auto Attendant use MMC 406 to set the
desired trunk(s) to ring station group 5049.
5. MMC 102: If you are using the SVMi-20E for Voice Mail make sure that all desired
stations are forwarded to station group 5049 for the appropriate call forward
conditions: No-Answer, Busy, and/or ALL.
6. MMC 740: Set "MBX Download" is to YES.
7. MMC 741: Select "NO" for each station that you DO NOT want to create a mailbox
for.
INITIALIZING THE SVMi-20E
Perform a proper SVMi-20E system shut down. (Steps for performing a proper shut
down are described in the section Correct System Shutdown.)
Once the SVMi-20E is down and at a C:> DOS prompt, Press the RESET button this
will reboot the SVMi-20E. During the Reboot process the SVMi-20E will communicate
through a series of IPC messages to the MP40 to read the MMC data and initialize the
SVMi-20E accordingly.
NOTE: After the SVMi-20E restarts you should change the value of MMC 740 so that it
indicates "MBX Download = No." This will prevent the system from overwriting any
future changes you make to the SVMi-20E database in regards to EXT and MBX
Blocks.
TESTING THE HARDWARE
1. Call each SVMi-20E port individually and confirm that SVMi-20E answers.
2. Call station group 5049 and confirm that SVMi-20E answers.
If steps 1 and 2 above proved to be successful you have completed the installation
and setup of the SVMi-20E hardware.
You are now ready to begin programming the SVMi-20E Voice Mail/Auto Attendant
system parameters.
NOTE: See MMC references in the SVMi-20E Programming Overview documentation
for other MMCs that interact with the SVMi-20E.
See the SAMSUNG SVMi-20E Programming Manual.
3.49
Table of Contents
Home Page
INSTALLATION
PART 3 JUNE 2006