Samsung OfficeServ 7400 Technical Manual page 97

OfficeServ 7400
TECHNICAL MANUAL
keyset aside. Attach the KDb-DLI to the keyset base with the four screws that are supplied
(see Figure 7.13). Take care to ensure that the modular socket shows through the
access hole in the base
and plug the ribbon cable into the socket on the keyset PCB
making sure that no damage occurs to the keyset PCB. Reattach the base to the
keyset and test to ensure normal keyset operation.
KDB-SLI
This daughterboard can be installed only in the DCS 12 or DCS 24 button keyset.
Before performing this procedure, unplug the line cord from the keyset and remove the
base wedge. Place the keyset face down on a soft surface and remove the four base
retaining screws (see Figure
keyset aside. Attach the KDb-SLI to the keyset base with the six screws that are
supplied (see Figure 7.16).
the access hole in the base
(see Figure 7.14). Invert the base assembly over the keyset
RETAINING SCREWS
RETAINING SCREWS
Figure 7.12 Keyset Base
7.12). Separate the base from the keyset and place the
Take care to ensure that the modular socket shows through
(see Figure 7.14). Invert the base assembly over the keyset
7.9
Table of Contents
Home Page
INSTALLATION
PART 7 JUNE 2006
(see Figure 7.15) while