Table 3.3 Types Of Control Boards - Samsung OfficeServ 7200 Technical Manual

OfficeServ 7200
TECHNICAL MANUAL
Switches 1 through 4 select the country the system is installed in.

4
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
Switch 5 is reserved.

Any changes to these switch settings after system start up will require a full system default

by holding the RESET button in for 7 seconds. Without this system default RESET any
previous settings will be retained even if the system has been shut down and powered up
again.
3.2.3 Installing MCP/MP20 and LCP
Install processor boards in slot 0 of the main cabinet and the expansion cabinet. The locations
of slot 0 through slot 5 are described in figure 3.1.
Control Board
MCP/MP20
LCP
The installation procedure for the MCP/MP20 and LCP boards is as follows:
1) Check the exterior of the MCP/MP20 board and the LCP board for any damage. If damage
is found, do not proceed with installation. Contact Samsung Technical Support.
Power the system OFF when installing or removing boards.
POWER TO THE CABINET MUST BE TURNED OFF. Failure to do so will damage the
card, cabinet and/or corrupt the data moving along the data bus.
3 2
OFF OFF
OFF OFF
OFF ON
OFF ON
ON OFF
ON OFF
ON ON
ON ON

Table 3.3 Types of Control Boards

Slot 0 of the main cabinet
Slot 0 of the expansion cabinet
3.6
Home Page
1 Country
OFF Korea
ON USA
OFF UK
ON Italy
OFF Australia
ON New Zealand
OFF Holland
ON Denmark
Applicable Slot
Table of Contents
INSTALLATION
PART 3 MAY 2010