Mounting Control Boards; Table 3.5 Position Of Optional Boards; Table 3.6 Types Of Control Boards - Samsung OfficeServ 7400 Installation Manual

Clas.
Description
There are three positions to mount optional boards in LP40.
Position of
Optional
Boards
Cautions for Mounting Optional Boards
The SCM board can be only mounted on one of LOC1 and LOC2, and the MIS
board can be only mounted on LOC3.

3.2.3 Mounting Control Boards

Mount LP40 and MP40, which are control boards, on Slot 0 and slot 3 in the basic cabinet
of the OfficeServ 7400 system. For expansion cabinets, LP40 and an interface board can be
mounted o slot0 and slot3, respectively. For the locations of Slot 0 through slot 11, refer to
'3.1. Cabinet Configuration' section of this chapter.
Control Board
MP40
LP40
The procedure for mounting the MP40 board and the LP40 board to each slot is as follows:
1) Check the exterior of the MP40 board and LP40 board for any damage. If any damage
has occurred in the exterior, stop the installation and contact your dealer.
Caution for the power when mounting boards
Check if the cabinet power is off when mounting boards on slots. Inserting or
ejecting a board while the power is on may damage the board or cause fire..
© SAMSUNG Electronics Co., Ltd.

Table 3.5 Position of Optional Boards

Positions for Optional Boards
LOC1 SCM, MFM, RCM, RCM2, CRM
LOC2 SCM, MFM, RCM, RCM2, CRM
LOC3 MIS

Table 3.6 Types of Control Boards

Slot 3 of the basic cabinet
Slot 0 of the basic/expansion cabinet
OfficeServ 7400 Installation Manual
Slot Available
3-7