Samsung OfficeServ 7400 Technical Manual page 65

OfficeServ 7400
TECHNICAL MANUAL
CORRECT SYSTEM SHUTDOWN
Whenever possible one of the following procedures should be followed when shutting
down the SVMi-20E system and/or prior to shutting down the Telephone equipment.
PROCEDURE ONE
1. From any phone on the system Log into KMMC Programming
2. Using MMC 746 change the status of eth SVMi-20E from "processing" to "Halt"
3. The SDN LED on the front of the SVMi-20E will change from RED to Green.
Green means it is safe to power down the switch.
PROCEDURE TWO
From the Main Status Screen (showing activity and port status):
1. Press 'Escape' and enter System Administration password (Default = 0000)
2. Select 'Operating Utilities'
3. Select 'Exit the SVMi-20E'
4. Enter System Administrator's password (Default = 0000)
5. The SDN LED on the front of the SVMi-20E will change from RED to Green.
Green means it is safe to power down the switch.
PROCEDURE THREE
1. From any phone on the system call one of the SVMi-20E ports or call the station
group 5049.
2. If the SVMi-20E answers with "please enter your password" press [*] to escape
to the main menu.
3. From the main menu press [#][0000]
4. You will be again prompted to enter a password, enter the System
Administrator's password (Default = 0000)
5. You will be prompted with "System Administration Menu" and a list of functions
you can perform. It will not be spoken, but you can enter a hidden option [4] to
shut down the system.
6. Again you will be asked to enter a password, enter the System Administrator's
password (Default = 0000)
7. The system will now shutdown to a C:> DOS Prompt. The SDN LED will turn
from RED to GREEN. Green means it is safe to power down the switch.
†
Also if you are logged in via an SIO Terminal, when the SVMi-20E terminal emulation
screen shows a DOS command line this also means the SVMi-2OE is no longer
processing and it is safe to power off the system and unplug the SVMi-20E card.
†
†
3.50
Table of Contents
Home Page
INSTALLATION
PART 3 JUNE 2006
†