Samsung OfficeServ 7400 Technical Manual page 103

Table of Contents
Home Page
OfficeServ 7400 INSTALLATION
TECHNICAL MANUAL PART 7 JUNE 2006
1
2 3
USED FOR ATTACHING
AOM OR 64B MODULE
WITH CONNECTOR CLIP
HOLES FOR MOUNTING SCREWS
NOTE: THE DIRECTORY CARD SLIDE TRAY IS NOT
Figure 7.21 Ultra Base Wedge
WALL-MOUNTING KEYSETS WITH ULTRA BASE WEDGE
The keysets now come equipped with a new Ultra Base wedge. These base wedges
are reversible and can be used for wall-mounting however not every wall mounting
scenario is appropriate. First and foremost there is only one keyhole in the center of the
base attaching to the wall, and these base wedges can not be used with the standard
wall mount bracket with the two buttons/pins. To wall-mount the keyset using Ultra
Base wedges use screw holes 1, 2 and 3 to mount the base wedge on dry wall with the
hole in the middle for cable access (see Figure 7.21).
WALL-MOUNTING iDCS KEYSETS
iDCS keysets come equipped with a reversible base wedge. To wall-mount a keyset,
remove the wedge from the keyset and mount the wedge to the wall using one of the
methods below (see Figure 7.22).
Use screw holes 1 and 2 to attach the base wedge to a standard electrical outlet box.
7.15