Pc System Requirements; Install The Configurator; Connect To The Emergency Phone - Mircom TX3 Series Installation And Operation Manual

Emergency phone
Table of Contents

Advertisement

3.1

PC System Requirements

For the PC based Configurator the minimum system requirements are:
Note:
3.2

Install the Configurator

The TX3 Configurator lets you program the Emergency Phone.
To install the Configurator
From the USB disk, run TX3-Config, and follow the instructions.
3.3

Connect to the Emergency Phone

To connect the computer to the Emergency Phone
1.
2.
TX3 Emergency Phone Installation and Operation Manual
34
LT-6113
Copyright 2017
Windows 8
Windows 7 (32 bit)
Windows XP SP2
512 MB RAM
1 GHZ CPU
600M disk space
1 USB port
Firmware upgrade is not supported on 64-bit systems.
Connect the computer to the TX3 network, or to the Emergency Phone
directly with:
a USB cable from the computer to P4 on the controller board (see Figure 4
on page 17).
an Ethernet TCP/IP connection (the Emergency Phone must have the
TX3-IP module).
If you have an existing TX3 network, go to section 3.3.1 on page 35. If you
have one or more Emergency Phones, go to section 3.3.2 on page 36.
Connecting
Version 2

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TX3 Series and is the answer not in the manual?

This manual is also suitable for:

Tx3-emer-1sTx3-emer-200ksTx3-emer-1s-cTx3-emer-200ks-c

Table of Contents