Updating Firmware - Mircom TX3 Series Installation And Operation Manual

To receive a call from the Emergency Phone
1.
2.
To call a resident from the guard phone
1.
2.
3.
2.16

Updating Firmware

You can update the firmware on your panel with the TX3 Configurator software
by using one of the following methods.
•
•
The Firmware Upgrade Wizard can be used to update only one panel at a time. It
will work on any panel. This method does not work on 64-bit versions of
Windows.
The Network Firmware Upgrade procedure can update more than one panel at the
same time. In order to use the Network Firmware Upgrade, all of the panels must
already have firmware that supports this feature installed on them.
Refer to LT-995, TX3 Configuration and Administrator Manual, for instructions
on how to perform both of these firmware upgrade methods. LT-995 can be found
on the TX3 Configurator Software installation CD, USB flash drive, or on the
Mircom website.
TX3 Emergency Phone Installation and Operation Manual
32
LT-6113 Copyright 2017
When a visitor dials 9997 on the Emergency Phone the guard phone rings.
Pick up the phone. The Emergency Phone is now connected to the guard
phone.
Press the # key on the guard phone. The main door unlocks.
Pick up the guard phone and wait for the dial tone.
Dial *DDDD (where DDDD is the resident's four digit dial code). The
resident phone rings. When the resident picks up the phone, the connection
is established.
Press the # key on the guard phone. The main door unlocks.
Firmware Upgrade Wizard
Network Firmware Upgrade
Installation
Version 2