Aimer Delay; User-Specified Aimer Delay; Aimer Mode; Centering - Honeywell Vuquest 3310g User Manual

Aimer Delay

The aimer delay allows a delay time for the operator to aim the scanner before the picture is taken. Use these codes to set the
time between when the button is pushed and when the picture is taken. During the delay time, the aiming light will appear, but
the LEDs won't turn on until the delay time is over. Default = Off.
200 milliseconds
* Off (no delay)

User-Specified Aimer Delay

If you want to set your own length for the duration of the delay, scan the bar code below, then set the time-out by scanning
digits (0 - 4,000 ms) from the

Aimer Mode

This feature allows you to turn the aimer on and off. When the Interlaced bar code is scanned, the aimer is interlaced with the
illumination LEDs. Default = Interlaced.
Off

Centering

Use Centering to narrow the scanner's field of view to make sure that when the scanner is hand-held, it reads only those bar
codes intended by the user. For instance, if multiple codes are placed closely together, centering will insure that only the
desired codes are read. (Centering can be used in conjunction with
in applications where multiple codes are spaced closely together. Using the Aimer Delay and Centering features, the scanner
can emulate the operation of older systems, such as linear laser bar code scanners.)
Note: To adjust centering when the scanner is in Presentation Mode, see
3 - 14
Programming Chart inside the back cover of this manual, then scan Save.
Delay Duration
Aimer Delay, page 3-14, for the most error-free operation
Presentation Centering
400 milliseconds
* Interlaced
(page 3-7).