Aimer Delay
The aimer delay allows a delay time for the operator to aim the scanner before
the picture is taken. Use these codes to set the time between when the button
is pushed and when the picture is taken. During the delay time, the aiming light
will appear, but the LEDs won't turn on until the delay time is over. Default =
Off.
200 milliseconds
* Off (no delay)
User-Specified Aimer Delay
If you want to set your own length for the duration of the delay, scan the bar
code below, then set the time-out by scanning digits (0 - 4,000 ms) from the
Programming Chart
Aimer Mode
This feature allows you to turn the aimer on and off. When the Interlaced bar
code is scanned, the aimer is interlaced with the illumination LEDs. Default =
Interlaced.
Off
3 - 18
inside the back cover of this manual, then scan Save.
Delay Duration
400 milliseconds
* Interlaced