Installing The Lens - Christie CP2208-LP Installation And Setup Manual

Installing the lens

The lens seals the projection head, preventing contaminants from entering the main electronics area.
Before installing the lens, ensure that you turn off and unplug the projector.
Do not operate the projector without a lens installed. Install a lens plug when you install or transport
the projector.
1. Remove the lens surround.
2. Turn the lens clamp on the front of the projector to the open position with a hex key.
3. Position the lens so the lens retaining ring mounts align with the lens mount.
4. Remove the lens caps from the front and rear of the lens.
Lens caps must be removed or they can melt and damage the lens.
5. Insert the lens straight into the lens mount opening without turning.
Magnets inside the lens mount help position the lens.
CP2208-LP Installation and Setup Manual
020-102152-03 Rev. 1 (05-2017)
Copyright 2017 Christie Digital Systems USA Inc. All rights reserved.
©
Installing and setting up
16