Table of Contents
Advertisement
Important safeguards
To prevent personal injury and to protect the device from damage, read and follow these safety
precautions.
General safety precautions
Read all safety and warning guidelines before installing or operating the projector.
Warning! If not avoided, the following could result in death or serious injury.
•
TRIP OR FIRE HAZARD! Position all cables where they cannot contact hot surfaces, be pulled, be
tripped over, or damaged by persons walking on or objects rolling over the cables.
•
This product must be installed within a restricted access location not accessible by the general
public.
•
Only personnel who are trained on the precautions for the restricted access location can be
granted entry to the area.
•
Install the product so users and the audience cannot enter the restricted area at eye level.
•
ELECTRICAL and BURN HAZARD! Use caution when accessing internal components.
•
High leakage current present when connected to IT power systems.
•
PERMANENT/TEMPORARY BLINDNESS HAZARD! No direct exposure to the beam must be
permitted. RG3 IEC 62471-5:2015
•
PERMANENT/TEMPORARY BLINDNESS HAZARD! Operators must control access to the beam
within the hazard distance or install the product at the height (greater than or equal to 2.0 m or
2.5 m (US only) from the floor to the beam) that prevents exposure of spectators' eyes within
the hazard distance.
•
Possibly hazardous optical radiation emitted from this product. (Risk group 3 under IEC
62471-5:2015)
•
For protection from ultraviolet radiation, keep all product housings intact during operation.
•
FIRE AND SHOCK HAZARD! Use only the attachments, accessories, tools, and replacement parts
specified by Christie.
•
A minimum of four people or appropriately rated lift equipment is required to safely lift, install,
or move the product.
•
Always install safety straps when the frame and projector are installed overhead.
•
Only Christie qualified technicians who are knowledgeable about the hazards associated with
laser use, high-voltage, and high temperatures generated by the product are authorized to
assemble, install, and service the Christie Laser Projection System.
CP2208-LP Installation and Setup Manual
020-102152-03 Rev. 1 (05-2017)
Copyright
2017 Christie Digital Systems USA Inc. All rights reserved.
©
FDA laser variance (US projectors only)
Safety precautions
7
Advertisement
Table of Contents
