Table of Contents
Advertisement
AC/power precautions
Read all safety and warning guidelines before connecting to AC power.
Warning! If not avoided, the following could result in death or serious injury.
•
SHOCK HAZARD! Only use the AC power cord provided with the product or recommended by
Christie.
•
FIRE AND SHOCK HAZARD! Do not attempt operation unless the power cord, power socket, and
power plug meet the appropriate local rating standards.
•
SHOCK HAZARD! Do not attempt operation if the AC supply is not within the specified voltage
and power range, as specified on the license label.
•
SHOCK HAZARD! The AC power cord must be inserted into an outlet with grounding.
•
SHOCK HAZARD! A dedicated, protected ground or earth wire must be installed on the product
by Christie qualified technicians or electricians before it can be connected to power.
•
SHOCK HAZARD! Disconnect the product from AC before moving, servicing, cleaning, removing
components, or opening any enclosure. Inputs A and B must be removed prior to servicing.
•
Install the product near an easily accessible AC receptacle.
•
The appliance coupler and main power supply plug must be easily accessible for disconnecting
the product from the power source.
Caution! If not avoided, the following could result in minor or moderate injury.
•
FIRE HAZARD! Do not use a power cord, harness, or cable that appears damaged.
•
FIRE OR SHOCK HAZARD! Do not overload power outlets and extension cords.
•
SHOCK HAZARD! Power supply uses double pole/neutral fusing. Disconnect all power sources
before opening the product.
•
Only Christie qualified technicians are permitted to open product enclosures.
Light intensity hazard distance
This projector has been classified as Risk Group 3 as per the IEC62471-5 standard due to possible
hazardous optical and thermal radiation being emitted.
Warning! If not avoided, the following could result in serious injury.
•
PERMANENT/TEMPORARY BLINDNESS HAZARD! No direct exposure to the beam must be
permitted. RG3 IEC 62471-5:2015
•
PERMANENT/TEMPORARY BLINDNESS HAZARD! Operators must control access to the beam
within the hazard distance or install the product at the height (greater than or equal to 2.0 m or
2.5 m (US only) from the floor to the beam) that prevents exposure of spectators' eyes within
the hazard distance.
•
EXTREME BRIGHTNESS! Do not place reflective objects in the product light path.
The following diagram and table show the zones for optical and thermal radiation hazard distances:
CP2208-LP Installation and Setup Manual
020-102152-03 Rev. 1 (05-2017)
Copyright
2017 Christie Digital Systems USA Inc. All rights reserved.
©
Safety precautions
8
Advertisement
Table of Contents
