Operation; Front Panel Features; Hdmi Audio Switch - Extron electronics XTP R HWP 201 User Manual

Operation

This section contains information for front panel operation and configuration of the
XTP R HWP 201. Topics in this section include:
•
•
•
•
•
After all transmitters, all receivers, and other related devices are connected and powered,
the system is fully operational. If any problems are encountered, verify that the cables are
routed and connected properly. If problems persist, call the Extron S3 Sales & Technical
Support Hotline.

Front Panel Features

Figure 14.
A
B

HDMI Audio Switch

The XTP R HWP 201 has an HDMI audio switch (see figure 14,
the embedded audio on the HDMI output connector. If necessary, remove the wallplate to
access the switch.
Move and hold the front panel HDMI audio switch up (on) for about 1 second to enable
embedded audio on the associated HDMI connector, or move and hold the HDMI audio
switch down (off) for about 1 second to disable embedded audio on the associated HDMI
connector. The switch returns to the middle position after it has been released so the device
can continue to be controlled through SIS commands.
Front Panel Features
HDMI Audio Switch
Audio Output Overview
Reset Mode
Side Panel Indicators
AUDIO
HDMI
L R
AUDIO
ON
OFF
OVER XTP
RS-232 IR
RESET
Tx Rx G Tx Rx
LAN
HDMI OUT
CONFIG
Front Panel Features
HDMI audio switch — Mutes or enables the embedded audio on the HDMI output
connector.
Reset button — Resets the device settings (see
A
B
Reset Mode
XTP R HWP 201 Wallplate Receiver • Operation
on the next page).
) that mutes or enables
A
17