Installation And Operation; Installation Overview - Extron electronics DTP3 T 202 User Manual

Installation and
Operation
This section describes the installation and the operation of the DTP3 transmitter and
receiver, including:
•
•
•
NOTE: These DTP3 devices are not compatible with DTP2 or DTP devices.

Installation Overview

To install and set up the transmitter and receiver:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Installation Overview
Connections
Operations
Turn off all equipment and disconnect it from the power source.
Mount the transmitter and receiver (optional) on a rack shelf or furniture (see
Equipment Mounting on page 30).
Connect an HDMI input source to the transmitter input (see figure 2,
page 5).
Connect an HDMI video display (optional) to the Loop Out port (see figure 2,
page 5) for local display.
Connect an HDMI output device to the receiver HDMI output (see figure 3,
page 6).
NOTE: LockIt cable lacing brackets are provided to secure the HDMI cables to the
port to reduce stress on the HDMI connectors and prevent signal loss due to loose
cable connections (see
Connect the transmitter Out RJ-45 port (see figure 2,
RJ-45 port (see figure 3,
C
Connect a balanced or unbalanced stereo or mono audio device to the
DTP3 R 201 via the Audio Out captive screw output (see figure 3,
Connect a serial RS-232 signal between the two 3.5 mm, 3-pole captive screw RS-
232 ports for bidirectional RS-232 communication (see figure 2,
and figure 3,
on the receiver).
D
Connect control devices. Connect your computer to the front panel Config port (see
figure 8, on page 11) to configure and control the transmitter and receiver via SIS
B
commands.
Power on the output display.
Securing the HDMI Connector
) using a twisted pair cable.
DTP3 T 202 / DTP3 R 201 • Installation and Operation
on
C
B
on
B
on page 8).
) to the receiver DTP3 In
D
).
E
on the transmitter
E
4