Operation - Extron electronics XTP R HDMI User Manual

Operation

After all transmitters, all receivers, and their connected devices are powered up, the system
is fully operational. If any problems are encountered, verify that the cables are routed and
connected properly. If problems persist, call the Extron S3 Sales & Technical Support
Hotline. See the contact numbers on the last page of this guide for the nearest Extron office.
Topics in this section include:
•
•
•
•
•
Front Panel Features
Transmitter Front Panel Features
Figure 11.
A
B
C
Front Panel Features
HDMI Audio Switch
EDID
Audio Output Overview
Reset Mode
A B
SIGNAL
CONFIG
HDCP
XTP T HDMI Front Panel Features
Power LED indicator — Lights when power is applied to the device from the power
supply. There are two Power LED indicators, one on the front panel and one on the rear
panel (see figure 2, on page 4).
G
Configuration port — Connect a host device to the female USB mini-B port to
configure the connected transmitter or receiver or update firmware.
Input LED indicators
Signal LED indicator — Lights when an active video signal is detected from the
•
source.
HDMI Audio LED indicator — Lights when the HDMI audio input is selected.
•
HDCP LED indicator — Lights when the input signal is encrypted.
•
Analog Audio LED indicator — Lights when the analog audio input is selected.
•
Audio Signal Clip LED indicator — Lights when the analog audio input signal
•
remains above -3 dBFS. The LED remains lit for 200 milliseconds after the signal
falls below -3 dBFS.
XTP T HDMI Transmitter and XTP R HDMI Receiver • Operation
C
INPUT
HDMI AUDIO
AUDIO SIGNAL CLIP
ANALOG AUDIO
XTP T HDMI
15