Operation; Front Panel Features And Indicators - Extron electronics XTP SR HDMI User Manual

Operation

This section contains information for front panel operation and configuration of the
XTP SR HDMI and configuration through the On-Screen Display (OSD) menu. Topics in this
section include:
•
•
•
•
•
•

Front Panel Features and Indicators

A
Figure 9.
A
B
C
D
E
Front Panel Features and Indicators
Rear Panel HDMI Audio Switch
Audio Output Overview
On-Screen Display Menu System
Front Panel Lockout Mode (Executive Mode)
Reset Mode
B C
XTP
SIGNAL HBR
CONFIG
HDCP HDMI
XTP SR HDMI Front Panel
Power LED indicators — Lights when power is applied to the unit. There are two
Power LED indicators, one on the front panel and one on the left side of the rear panel.
Configuration port — If desired, connect a host device to the front panel USB mini-B
port for configuring the scaling receiver.
XTP indicators:
Signal LED indicator — Lights when an active XTP input signal is received.
•
HDCP LED indicator — Lights when the received input signal is encrypted.
•
Audio indicators:
HBR LED indicator — Lights when the audio input is high bit rate audio.
•
Bitstream LED indicator — Lights when the embedded audio signal format is a
•
Dolby Digital, DTS, or 2-Ch Dolby.
®
LPCM LED indicator — Lights when the embedded audio signal is LPCM-2Ch.
•
HDMI LED indicator — Lights when the HDMI audio output is enabled.
•
S/PDIF LED indicator — Lights when the S/PDIF audio output is enabled.
•
Analog LED indicator — Lights when the analog audio output is enabled.
•
Menu button — Press this button to navigate the OSD menu or enable or disable front
panel lockout mode (see Front Panel Lockout Mode (Executive Mode)
page 22).
D E F
AUDIO
BITSTREAM LPCM
S/PDIF ANALOG
MENU ENTER
XTP SR HDMI Scaling Receiver • Operation
G
ADJ ADJUST UST
X TP X X X XTP SR HDMI
on
14