How To Get Started; Connecting Speakers - Lyngdorf Audio TDAI-1120 Owner's Manual

•
Press and hold for more than five seconds to initiate Wi-Fi setup
using Apple WAC
•
Press and hold for more than ten seconds to initiate Wi-Fi setup
using WPS
7. Volume wheel
•
Adjust the volume with left or right rotation. Light indicator for
volume setting.
8. Standby button
•
Short press to turn the TDAI-1120 on or into standby mode
•
Press and hold for more than five seconds to initiate factory reset.
If held for more than ten the procedure is aborted.
Note: See more about Wi-Fi setup in the section "Turning on the TDAI-1120
for the first time."

How to get started

Before you connect the TDAI-1120 to mains power, you need to connect
loudspeakers and other sources of audio. If you have a local network,
connection by wire is recommended, as it provides a more stable and faster
network connection than Wi-Fi.
The TDAI-1120 features a wide range of connectors on the back for
external audio sources in addition to the streaming options available
through Bluetooth or your network.

Connecting speakers

When connecting the speakers,
always connect + and - from the
amplifier to the corresponding + and -
terminals on the speaker.
Lyngdorf Audio TDAI-1120 – Owner's manual
ANALOG AUDIO MODULE HDMI MODULE RIGHT
INPUT OUTPUT
L
HDMI 1 HDMI 3
R
A3 A4 A5 A6 RIGHT A6 LEFT
HDMI 2 HDMI 4 OUT CLASS 2 WIRING
TRIGGER
ANALOG DIGITAL IN
INPUT OUTPUT
D1 INPUT OUTPUT
USB MODULE
L
USB AUDIO IN
R
A1 A2 MICROPHONE D2 D3 D4 D5 D6
SW RS232 TRIGGER
UPDATE OUT
ENG
DE
LEFT
TDAI 2170
13
FR