Johnson Controls Metasys Intelligent Fire Network Technical Manual page 65

IFC Panel
CCBE
Programming
Full Point
Programming
PRESS 1=PSYS, 2=FSYS, 3=PPRG, 4=FPRG, 5=REMV, 6=PSWD, 7=MSG, 8=HIS
ENTER LXX (D/M) YY, ZXXX OR AXXPYY FOR PT. INSTALL (BCKSPC TO ABORT)
ENTER TYPE ID
ENTER CONTROL BY EVENT
ENTER COOPERATIVE CONTROL-BY-EVENT
OR (N8Z1 N8Z2 N8Z3 N8Z4 AND [N9Z1 N9Z2 N9Z3 N9Z4] AND [N10Z1 N10Z2 N10Z3 N10Z4])
ENTER 20 CHARACTER CUSTOM LABEL
DO YOU WANT THIS POINT MAPPED TO AN ANNUNCIATOR? (Y=YES, N=NO)
Partial Point
Programming
Full point programming is usually used when programming a new point to
the system.
The following is an example of full point programming a RZON:
Partial point programming is usually used to change or update information
to an existing point.
The partial point-programming submenu has six options, where:
1=TYPID Type ID - Changing the software type identification of
SLC loop devices, zones, and annunciator points.
2=CBE Control-By-Event - Edit the Control-By-Event associated with
each detector, module, or zone.
3=LBL Label - Renaming the custom user label for any detector, module,
or zone.
4=OPTNS Options - Selecting the optional features associated with any
detector or module.
5=AMAP Annunciator Point Mapping - Selecting Annunciator Point
Mapping for any detector, module, or zone.
6=CCBE Cooperative Control-By-Event - Edit the CCBE associated with
reverse activated zones.
IFC Networking—Metasys Intelligent Fire Network
: 4
: Z220
: RZON
: ( )
:
:
: N
65