Delta HES Series Instructions For Use Manual page 88

Chapter 4 Parameter Functions
 Decode temporarily or cancel the password then you will be able to use keypad to copy
parameters. But the password set at Pr02-22 will not be copied. When the parameters saved in
the keypad are transferred to the hybrid servo drive, you will need to set up a password at
Pr02-22 to enable parameter protection.
Set up a password
P r02-22
When you finish setting up a
password keypad will
display 1 which means the
password protection is now
effective.
Password Decode Flow Chart
Pr0 2 -2 2
Se t u p a
p a ssw o rd
~
HES Series
Forget your password?
Input 9999 and press ENTER,
then repeat inputting 9999
and pressing ENTE R
complete the decoding
procedure.
has to be done in10 sec..
If you don't finish that in
10 sec.,repeat the same
procedure until you finish the
procedure in10 sec
Once you finish this decoding
process, all the parameters
will be back to the factory
settings.
Pr0 2 -2 1
Se t
D e co d e th e
Pr0 2 -2 2 =0 ?
p a ssw o rd
P o we r o ff a n d
r e - p o we r o n ,
th e p a sswo r d i s sti l l
a va i l a b l e .
Reserved
Pr02-21
to
(This procedure
Power off and
Ye s
re-power on to
cancel the password.
N o
4-36
Wrong password?
Pr02-21
You only have 3 password
trials to enter the correct
password.
If the 1st attempt is incorrect,
the keypad will display 01.
if the 2nd attempt is incorrect,
the keypad will display 02.
If the 3rd attempt is incorrect,
the keypad will display03.
If the 4th attempt is still wrong
the keypad will display
blinking error code <P code>.
A fter 3 failed logon attempts,
the keypad will be locked.
P ower off the motor drive
and then re-power on
to enter the password.