Delta HES Series Instructions For Use Manual page 64

Chapter 4 Parameter Functions
4-2 Description of Parameter Settings
00 System Parameters
Hybrid Servo Controller model code ID
VF
Control mode
Settings
Display of rated current of the Hybrid Servo Controller
Control mode VF
Settings
 Parameter 00-00 is used to determine the capacity of the Hybrid servo motor which has been
configured in this parameter in factory. In addition, the current value of Parameter (00-01) can
be read out to check if it is the rated current of the corresponding model. Display value of the
current value of Parameter 00-01 for the related Parameter 00-00.
Power (KW)
Horse Power (HP)
Model ID
Power (KW)
Horse Power (HP)
Model ID
Reset parameter settings
Control mode VF
Settings
 If it is necessary to restore the parameters to factory default, just set this parameter to "10".
Software version
Control mode VF
Settings

Selection of multi-function display
Control mode VF
Settings
HES Series
FOCPG FOCPM
Read only
FOCPG FOCPM
Read only
5.5 7.5
7.5 10
12 14
5.5 7.5 11
7.5 10 15
13 15 17
FOCPG FOCPM
0: No function
1: Parameter locked
5: Rest the kWh at drive stop
10: Reset parameter values
FOCPG FOCPM
Read only
FOCPG FOCPM
0: Display the output current (A)
1: Reserved
2: Display the actual output frequency (H)
3: Display the DC-BUS voltage (U)
4: Display the output voltage (E)
5: Display the output power angle (n)
6: Display the output power in kW (P)
 You can set this parameter during operation
230V Series
11 15 18.5
15 20 25
16 18 20
460V Series
15 18.5 22 30
20 25 30 40
19 21 23 25
4-12
Factory default: Read only
Factory default: Read only
22 30 37
30 40 50
22 24 26
37 45 55 75
50 60 75 100
27 29 31 33
Factory default: 0
Factory default: #.##
Factory default: 0
U
U
U
U
U
U