Installation Guide Linear Motors
3 Installation Instructions
3.1 Operating Conditions
•
Maximum ambient temperature limits: 0 °C
•
Internal temperature sensor error occurs at: 120 °C
•
The motors must not be operated under water.
1)
Lower temperatures on request.
3.2 Assembly of the Linear Motor
Please attend to the safety instructions in chapter 2 during the assembling!
NTI AG / LinMot
...80 °C
1)
Do not hold the stator by the cable
during handling.
The tensile strength of the cable is
only 10 N.
Clean the slider with a paper towel.
Lubricate the slider.
Sliders with a length of more than 500 mm are
lubricated with a grease quantity of 4 g (approx.
½ hazelnut) per meter. Shorter sliders are
inserted without lubrication.
The grease can be applied by hand or with a
soft paper towel.
Always observe the specified grease
quantity. Over lubrication leads to a
gumming of the grease, which
appears particularly at higher
operating temperatures!
P01-23-HP-SSCP
ENG
Seite 7 / 30