Table of Contents
Advertisement
Distance Measurement
FIGURE 18.
Measure
Distance
Measure the distance from the top of the telescope stem to the top of the steering wheel hub to verify the
4.
distance is close to the measurement taken when the steering wheel was removed.
Note:
If the distance is not close to the first measurement:
1. Remove the spline nut, washer, and assembly bolts.
2. Remove the male spline adapter.
2. Loosen the set screws used to secure the installed telescope adapter.
3. Adjust the placement of the telescope adapter on the machine's telescope rod, relative to the
distance between the two measurements.
4. Tighten the set screws and reinstall the male spline adapter and assembly bolts.
5. Reinstall the spline washer and nut.
Reinstall the machine's steering wheel telescope knob.
5.
Reinstall the nut that was removed during the steering wheel removal on the protruding telescope adapter
6.
(P/N 063-4001-023).
Replace the steering wheel cap.
7.
Install the Mechanical Drive
Note:
Depending on the machine's configuration, it may be necessary to install the anti-rotation pin in the
mechanical drive's casing after the mechanical drive is installed instead of before as indicated in
the instructions below.
P/N 016-5030-051 Rev. B
Mechanical Drive Installation
17
Advertisement
Table of Contents
