Route the foot switch cable to the node mounting location.
4.
Install the Node Harness
Node Harness Installed on SmarTrax Node
FIGURE 8.
Install the two large, rectangular connectors of the node harness (P/N 115-4001-157) into the correct ports
1.
of the node (P/N 063-4001-013), tightening the bolts on the connectors to secure the connections.
Tighten the bolts on the harness connectors to secure the connections.
2.
Connect the female 4-pin Deutsch connector to the cable of the installed foot switch (P/N 063-0173-593).
3.
Connect the node harness to the operator presence switch, if applicable.
4.
Locate and disconnect the machine's existing OPERATOR PRESENCE connection behind the
a.
operator's seat, if applicable.
Connect the round 4-pin connector from the node harness to the machine's mating OPERATOR
b.
PRESENCE connector.
Mechanical Drive Connection
FIGURE 9.
Connect the 8-pin Deutsch connector from the node harness into the 8-pin port of the mechanical drive
5.
(P/N 063-4001-010).
P/N 016-5030-051 Rev. B
Node and Wiring Installation
25